Oreck XL2000HH Manual De Usuario

4

O

perating

I

nstructions

To Operate
Make sure disposable paper filter dust bag is in place. DO NOT
operate the cleaner without a paper filter dust bag. Plug the
power cord into an electrical outlet and press the On 

- OFF

switch on Helping Handle Assembly, or on top of base for

Straight Handle Models when ready to operate.

General Information
The performance of your new cleaner greatly depends upon care
and maintenance. The instructions in this manual will guide you in
performing basic care and maintenance. To obtain the most satis-
fying years of service read the instructions and keep them handy
for future reference.

Operating Recommendations
This new ORECK XL High-Speed Upright is one of the finest,
fastest, and strongest units in its class. You’ll love the way it
cleans, gets under things, and it’s SO lightweight and easy to
use.
The following are a few simple suggestions regarding its
operation:

1. When inserting a new disposable paper filter dust bag—

FIRST PUFF OUT and OPEN THE BAG.

2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the machine does not pick up properly or

makes an unusual noise, STOP OPERATION and service.

4. Although your upright will pick up pins, paper clips, and

other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do so
may result in permanent damage to the motor suction fan
and its housing.

5. WARNING: Do not use your vacuum cleaner on damp or

wet surfaces. This will cause damage to the vacuum cleaner
and is dangerous to the user. Damage caused by use on wet
or damp surfaces is not covered under warranty.

6. REPLACE THE BELT EVERY 6 MONTHS.
7. Change the disposable filter dust bag at least once a

month—even if it is not full! The collected dust in the dust
bag can cause odor, attract moisture, act as a breeding
area and can affect the efficiency of the cleaner.

8. DO NOT 

run the vacuum cleaner over cord. The revolving

brush could damage the cord.

To assist you in identifying 
components of your vacuum, 
the parts have been numbered 
as follows:

1 Handle section, upper

2 Tube, lower

3 Power head

4 Outer bag

5 Paper filter dust bag

6 Power cord

7 Retaining spring

8 Bag tension bar

9 Zip fastener

10 On/off switch

11 Cord hook

12 Plastic loop/

cable clamp

13 Connector assembly

14 Fan housing

15 Cord assembly

A

ssembly

Machine should be in upright

position when inserting cord

assembly into loop.
Insert plug on cord assembly

into handle.
Wrap power cord (6) around

cord wrap (11) and cord

wrap (13) and secure to “U”

shaped part on plug.

A

ssembly

6

15

14

7

10

13

11

12

8

9

5

1

2

3

4

Before assembling appliance.

Remove two screws from

connector assembly. Slide

upper handle section over

matching section of the

connector assembly. Place

brace against handle and

connector assembly aligning

screw holes. Insert screws in

holes and tighten firmly until

handle is no longer loose.