Clarke GU 12 DMU Manual De Usuario

 13

The pre fi lter catches any dirt spilled from the bag, before it can enter 
the vacuum motor. The fi lter is located below the bag.
Clean the fi lter every third time that the bag is changed (more often in 
very dusty applications).

 T

o clean/replace the Pre Filter.

1.    Disconnect the power cord from the electrical outlet. Then  

         

       push the Dust lid button (16) in and remove the dust lid (5). 
2.    Grasp at the fi lter holder and pull the holder out from the  

 

       Dust compartment. 
3.    Remove the dirty fi lter and replace with a new pre fi lter. 
       The pre fi lter may also be washed. Wash it in warm 
       water. Let the fi lter dry completely before putting it back into  

       

       the fi lter holder. 
4.   This machine is also equipped with a deodorizer function (an anti           
       smell). It´s a located in the pre fi lter holder. 
       Replace it to a new deodorizer when the function begins to  

 

       fade.
5.    Put back the new/washed fi lter into the holder. Then put back the  
       holder with fi lter in place at the bag housing.
6.    Fit the two notches of the back cover to the two slots at the lower  
       part of the bag housing, and push the back cover back 
       in place at the housing.

1.    Disconnect the power cord from the electrical outlet. 
       Push the Filter Cover Latch 

 downwards so that the Filter  

       Cover 

is released.

2.    Remove the cover with the fi lter, from the cleaner.
3.    Remove the used and dirty exhaust fi lter.
4.    Insert a new exhaust fi lter to the fi lter cover.
5.    Snap the Filter Cover back in place at the cleaner.

1. Unplug the Power Cord from the electrical outlet.

2. If the Dust Bag Full” Indicator (15) not has been lightened 

during operation -  the dust bag still have fi lling capacity. Open 
the dust housing cover to ensure that the dust bag not is 
full, replace if necessary.  See also separate instructions for 
replacing the dust bag. Clean the bag housing, if necessary.

3. Wind up the cord (starting from the machine inlet side).

4. Store the cord at the hook at the Dust lid cover and the hook 

at the handle.

5. Check the brush house. Remove any built-up carpet fi bers or 

debris from the brush and the brush housing. 

6.  Store the machine indoors in a clean, dry place.