Emerson Model 1700 Manual De Usuario

Normal

Transmitter calculates process variables at the standard speed.

Special

Transmitter calculates process variables at a faster speed.

The alarm handling parameters control the transmitter’s response to process and device
conditions.

Alarm handling parameters include:

•

Fault Timeout

•

Status Alarm Severity

5.5.1

Configure Fault Timeout

Display (standard)

Chinese-language
display

ProLink II

ProLink

 > Configuration > Analog Output > Last Measured Value Timeout

ProLink

 > Configuration > Frequency/Discrete Output > Frequency > Last Measured Value Timeout

ProLink III

Device Tools

 > Configuration > Fault Processing

Field Communicator Configure > Alert Setup > Alert Severity > Fault Timeout

Fault Timeout

 controls the delay before fault actions are performed.

Fault Timeout

 is applied only to the following alarms (listed by Status Alarm Code): A003, A004, A005,

A008, A016, A017, A033. For all other alarms, fault actions are performed as soon as the alarm is
detected.

Set Fault Timeout as desired.

The default value is 0 seconds. The range is 0 to 60 seconds.

If you set Fault Timeout to 0, fault actions are performed as soon as the alarm condition is
detected.

The fault timeout period begins when the transmitter detects an alarm condition. During
the fault timeout period, the transmitter continues to report its last valid measurements.

Configure device options and preferences

71