Sennheiser SR 2050 IEM Manual De Usuario
If a problem occurs ...
24
If a problem occurs ...
If a problem occurs that is not listed in the above table or if the problem cannot be solved with
the proposed solutions, please contact your local Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at www.sennheiser.com under “Service
& Support”.
the proposed solutions, please contact your local Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at www.sennheiser.com under “Service
& Support”.
Problem
Possible cause
Possible solution
Transmitter cannot be
operated, “
operated, “
Locked
”
appears on the display
panel
panel
Lock mode is activated
No operation indication
No mains connection
Check the connections of the
mains cable (see page 12).
mains cable (see page 12).
No RF signal at the
receiver
receiver
Transmitter and receiver are
not on the same channel
not on the same channel
If “
RF Mute
” additionally
appears on the transmitter
display:
RF signal is deactivated
display:
RF signal is deactivated
Activate the RF signal
(see page 14).
(see page 14).
Very weak RF signal at
the receiver
the receiver
Transmission range is
exceeded
exceeded
Check the squelch threshold
setting on the receiver.
setting on the receiver.
Reduce the distance between
receiver and transmitter.
receiver and transmitter.
Increase the transmission
power (see page 19).
power (see page 19).
Receiver’s squelch threshold is
adjusted too high
adjusted too high
Reduce the squelch threshold
(see the instruction manual of
the receiver).
(see the instruction manual of
the receiver).
Reposition the antennas.
RF signal available,
no audio signal at the
receiver
no audio signal at the
receiver
No input signal at the
transmitter
transmitter
Very low input signal
Check the audio level on the
transmitter display (see
page 7), increase the level of
the input signal or adjust the
input sensitivity (see page 19).
transmitter display (see
page 7), increase the level of
the input signal or adjust the
input sensitivity (see page 19).
Audio signal has a high
level of background
noise
level of background
noise
Transmitter sensitivity is
adjusted too low
adjusted too low
Adjust the transmitter sensi-
tivity correctly (see page 19).
tivity correctly (see page 19).
Audio signal is distorted If “
AF PEAK
” additionally
appears on the transmitter
display:
transmitter sensitivity is
adjusted too high
display:
transmitter sensitivity is
adjusted too high
Adjust the transmitter
sensitivity correctly.
sensitivity correctly.
Receiver’s audio output level
is adjusted too high
is adjusted too high
Reduce the audio output level
(see the instruction manual of
the receiver).
(see the instruction manual of
the receiver).