Bradford-White Corp DS150S Manual De Usuario

 

 

 

Water heaters are heat producing appliances. To avoid damage or injury, do 
not store materials against the water heater or vent-air intake system.  Use 
proper care to avoid unnecessary contact (especially by children) with the 
water heater and vent-air intake components. UNDER NO CIRCUMSTANCES 
MUST FLAMMABLE MATERIALS, SUCH AS GASOLINE OR PAINT 
THINNER BE USED OR STORED IN THE VICINITY OF THIS WATER 
HEATER, VENT-AIR INTAKE SYSTEM OR IN ANY LOCATION FROM 
WHICH FUMES COULD REACH THE WATER HEATER OR VENT-AIR 
INTAKE SYSTEM. 

 

DO NOT install the water heater in any location where gasoline or 
flammable vapors are likely to be present. 
 
Water Heaters in residential garages shall be installed so that all 
burner(s) and burner ignition device(s) are located not less than 18 
inches  (46 cm) above the floor and shall be located, or protected, to 
avoid physical damage.  For other installations refer to local codes.  In 
the absence of local codes, the water heater shall be installed in 
compliance with the National Fuel Gas Code, ANSI Z223.1 - (Latest 
Edition) and/or in Canada, CAN/CGA B149 Installation Codes (Latest 
Editions). 
  
The location of this water heater is of the utmost importance. Before installing 
this water heater, read the installation section of these instructions. After 
reading these installation and operating instructions, select a location for the 
water heater where the floor is level and is easily accessible to gas and water 
supply lines. DO NOT locate the water heater where water lines could 
be subjected to freezing temperatures.  Make sure the cold water pipes 
are not located directly above the gas control so that condensate 
during humid weather does not drip on the controls.