Bradford-White Corp IGE-199R Series Manual De Usuario

Descargar
Página de 44
LIGHTING INSTRUCTIONS 
 
FOR YOUR SAFETY READ BEFORE OPERATING 
WARNING:  If you do not follow these instructions exactly, a fire or explosion may result causing 
property damage, personal injury or loss of life. 
A.  This appliance does not have a pilot.  
It is equipped with a direct ignition 
device, which automatically lights 
the burner.  Do not try to light the 
burner by hand. 
C.  Use only your hand to operate the remote 
control keypad.  Never use tools.  If the 
remote keypad doesn’t work, do not try to 
repair it, call a qualified service technician.  
Forced or improper repair may result in a fire 
or explosion. 
B.  BEFORE OPERATING:  Smell all 
around the appliance area for gas.  
Be sure to smell next to the floor 
because some gas is heavier than 
air and will settle on the floor. 
D.  Do not use this appliance if any part has been 
under water.  Immediately call a qualified 
service technician to inspect the appliance 
and to replace any part of the control system 
and any gas control, which has been under 
water. 
WHAT TO DO IF YOU SMELL GAS 
•  Do not try to light any appliance. 
•  Do not touch any electric switch; do 
not use any phone in your building. 
 
 
•  Immediately call your gas supplier from a 
neighbor’s phone.  Follow the gas supplier’s 
instructions. 
•  If you cannot reach your gas supplier, call the fire 
department.  
OPERATING INSTRUCTIONS 
1.  STOP!  Read the safety information 
above before proceeding. 
6.  Wait (5) minutes to clear out any gas.  If you    
then smell gas, STOP!  Follow “B” in the safety 
information above on this label.  If you don’t smell 
gas, go to next step. 
2.  Set the thermostat to the lowest 
setting. 
7.  Turn the manual valve located at the gas inlet   of 
appliance counterclockwise 
 
 to “ON” (see 
Figure 9). 
3.  Turn off all power to the electrical 
appliance. 
8.  Turn on all electric power to the appliance. 
4.  This appliance does not have a pilot.  
It is equipped with a direct ignition 
device, which automatically lights 
the burner.  Do not try to light the 
burner by hand. 
9.  Set the thermostat to desired setting. 
 
10.  If the appliance will not operate, Follow the 
instructions “To Turn Off Gas To Appliance” and 
call your service technician or gas supplier. 
5.  Turn the manual valve located at the 
gas inlet of the appliance clockwise 
 
 to “OFF” (see Figure 9). 
 
TO TURN OFF GAS TO THE APPLIANCE 
1.  Set the thermostat to the lowest 
setting. 
3.   Turn the manual valve at gas inlet of appliance   
clockwise 
 
 to “OFF” (see Figure 9). 
2.  Turn off all electric power to the 
appliance if service is to be 
performed. 
 
 
 
Manual Gas Valve (Fig 9) 
 
29