Bradford-White Corp IGE-199R Series Manual De Usuario

 

120°F (49

°C)  More than 5 minutes

125°F (52

°C)  1½ to 2 minutes 

130°F (54

°C)  About 30 seconds 

135°F (57

°C)  About 10 seconds 

140°F (60

°C)  Less than 5 seconds

145°F (63

°C)  Less than 3 seconds

About 1½ seconds 

150°F (66

°C) 

About 1 second 

155°F (68

°C) 

1.  Remove all wet clothing quickly.  Wet clothing retains the heat. 
2.  Apply cold water to burned area for 30 minutes to reduce the heat in the skin and prevent deeper 

burning.  Never use butter, oils, or ointment to cover the burn.  They may retain the heat. 

3.  Use a blanket to keep the scalded person warm. 
4.  Seek medical advice. 

 
ERROR MESSAGES ON REMOTE TEMPERATURE CONTROL DISPLAY 
 
The Bradford White EVERHOT

® tankless water heaters have the ability to monitor and display any 

operating faults on the remote temperature control display.  The error messages will display on the 
monitor and will assist in servicing the water heater.  The following is a listing of the error codes that may 
flash on the remote monitor in case of a malfunction with the water heater.  Please quote the code 
displayed when calling for service. 

 

Code 

Displayed 

Fault Remedy 

10 

Air supply or exhaust blockage 

Check for a restriction in the exhaust vent.   

11 

No Ignition 

Check to make sure the gas supply is on to the 

water heater. 

12 

Flame Failure, grounding failure 

Make sure gas is turned on at the water heater; 

check for obstructions in exhaust vent. 

14 

Thermal Fuse 

Heat exchanger overheated 

16 Over 

Temperature 

Warning Excessive temperatures, wrong dip switch 

setting, incorrect manifold pressure or gas type. 

32 

Outlet water temperature faulty 

Outlet sensor or wiring may be defective 

33 

Heat exchanger outlet water temperature 

faulty 

H.E. outlet sensor or wiring may be defective. 

34 

Combustion air sensor faulty 

Thermistor or wiring faulty 

52 

Modulating Solenoid Valve signal 

abnormal 

Check gas control and wiring 

61 

Combustion Fan Failure 

Combustion fan or wiring faulty 

71 

Solenoid Valve Driving Circuit Faulty 

Check all gas solenoids and wiring 

72 

Flame Sensing Device Faulty 

Lack of flame sense – check flame rod and 

wiring connections. 

LC 

Scale build-up in Heat Exchanger 

Build up of lime scale in heat exchanger – 

needs to be flushed. 

(00) 

(When checking maintenance code 
history, “00” is substituted for “LC”). 

 

If any of the above error codes are seen flashing on the remote display, call for service. 
 

 

WARNING

 

 

34