Bradford-White Corp PE-4-403S6FBN Manual De Usuario

3 

to light the pilot by hand.

A. This appliance is equipped with an ignition device

which automatically lights the pilot. Do not try

FOR YOUR SAFETY READ BEFORE 

WARNING: If you do not follow these instructions exactly, a fire or explosion

may result causing property damage, personal injury or loss of life.

If you cannot reach your gas supplier, call the

fire department.

B. BEFORE OPERATING smell all around the 

ance area for gas. Be sure to smell next to the

floor because some gas is heavier than air and

Do not touch any electrical switch; do not use

neighbor's phone. Follow the gas supplier's

TO TURN OFF GAS TO APPLIANCE

OPERATING INSTRUCTIONS

will settle to the 

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

instructions

any phone in your building.

Immediately call your gas supplier from a

C. Use only your hand to slide the gas control switch.

Never use tools. If the switch cannot be moved by

hand, do not try to repair it, call a service

technician. Force or attempted repair may result in

D. Do not use this appliance if any part has been

under water. Immediately call a qualified 

technician to inspect the appliance and to replace

 

any part of the control system and any gas

control which has been under water.

a fire or 

Appliance" and call your 

gas valve down to the "OFF" position

5. Slide the switch on the right side of the

technician or gas 

the pilot by hand.

3. Set the thermostat to lowest setting.

2. Turn off all electric power to the

1. STOP! Read the safety information above.

lights the pilot. Do not try to light

ignition device which 

4. This appliance is equipped with an

appliance

Smell for gas, including near the floor.

the instructions "To Turn Off Gas To

10. If the appliance will not operate, follow

If you the smell gas, STOP! Follow

"B" in the safety information at left on

this label. If you don't smell gas, go to

7. Slide the switch on the right side of the

gas valve up to the "ON" position.

8. Set thermostat to desired setting.

9. Turn on all electric power to the appliance.

the next step.

6. Wait five (5) minutes to clear out any gas.

1. Turn off all electric power to the 

appliance if service is to be 

2. Set the thermostat to the lowest setting.

3. Slide the switch on the right side of the 

gas valve down to the "OFF" position.

HOT

LOW

HOT

VERY

SWITCH SHOWN
IN "ON" POSITION

A

B

C

THERMOSTAT

DIAL

ON

OFF

STATUS

Honeywell