Baldor iMN1800 Manual De Usuario
2-4 Installation & Operation
MN1800
LMBL Series
Brushless Linear Iron Core Servo Motor
Installation
Refer to Figure 2-1.
1.
Install the magnet assembly onto the machine mounting base.
2.
With the slide assembly removed from the rails, install the coil assembly onto
the slide, tightening the mounting screws.
the slide, tightening the mounting screws.
3.
Place a non–magnetic shim over the magnets, sized to cover all the magnets.
(The shim thickness must be equivalent to the air gap specification. The normal
air gap is 0.030
(The shim thickness must be equivalent to the air gap specification. The normal
air gap is 0.030
″
±
0.005
″
unless otherwise specified).
4.
Install and push the slide along the rails, positioning the coil assembly directly
over the shim.
over the shim.
(An alternate method is to install the slide on a set of rails that is identical to the
one being used. Butt the temporary rails to the system rails and transfer the
slide onto the system rails.)
one being used. Butt the temporary rails to the system rails and transfer the
slide onto the system rails.)
For either method, it is extremely important to uniformly tighten the mounting screws.
Improper tightening will bend the primary or secondary and damage the motor.
If there is not enough space to install the coil assembly as described, use this alternate
procedure.
Alternate Installation Refer to Figure 2-1.
Improper tightening will bend the primary or secondary and damage the motor.
If there is not enough space to install the coil assembly as described, use this alternate
procedure.
Alternate Installation Refer to Figure 2-1.
1.
Place the non–magnetic shim on the magnet track.
2.
With a firm grip on the coil assembly, place one end of it on the shim and slide it
into place, centered over the magnets. Be careful not to let the magnet and coil
“Slam” together.
into place, centered over the magnets. Be careful not to let the magnet and coil
“Slam” together.
3.
Align the fastening screw holes on the slide with the holes on the coil assembly.
4.
Loosely install all the mounting screws.
5.
Insert enough shims between the slide and the coil assembly to fill the gap.
6.
Tighten all the mounting screws, alternating in a systematic manner while
tightening such that the coil assembly is drawn–up evenly leaving a uniform air
gap between the coil assembly and the magnets. This air gap must be
maintained along the entire length of the magnet assembly i.e.; the coil
assembly must never touch the magnets at any point when moving along the
length of the magnet assembly and the air gap specification must be
maintained at all times.
tightening such that the coil assembly is drawn–up evenly leaving a uniform air
gap between the coil assembly and the magnets. This air gap must be
maintained along the entire length of the magnet assembly i.e.; the coil
assembly must never touch the magnets at any point when moving along the
length of the magnet assembly and the air gap specification must be
maintained at all times.
7.
Remove the shim that sets the air gap prior to operation.
Figure 2-1 Air Gap Adjustment
ÉÉÉÉ
Slide
Rail
Coil Assembly
Magnet
Air Gap (0.30
±
0.005)
Shim
(if necessary)
(if necessary)
Base