Brother S-7200C Manual De Usuario

 

 

S-7200C

 

118

１０

-４. Adjusting arm thread guide R 

The standard position of arm thread guide R (1) is the 
position where the screw (2) is in the center of the adjustable 
range for arm thread guide R (1). 

*  To adjust the position, loosen the screw (2) and then 

move arm thread guide R (1). 

・ 

When sewing thick material, move arm thread guide R 

(1) to the left. (The thread take-up amount will become 
greater.) 

・ 

When sewing thin material, move arm thread guide R 
(1) to the right. (The thread take-up amount will 
become less.) 

 

 
 
 
 
 
 

１０

-５. Adjusting the presser foot height 

The standard height of the presser foot (1) is 6 mm when the 
presser foot (1) is raised by means of the lifting lever (2). 
1.   Loosen the nut (3) of the adjustment screw (4), and then 

turn the adjustment screw (4) so that there is no pressure 
applied to the presser foot. 

2.  Raise the lifting lever (2). The presser foot (1) will also 

rise. 

3.   Remove the oil cap (5). 
4.   Loosen the bolt (6) and then move the presser bar (7) up 

or down until the presser foot (1) is at the standard height 
of 6 mm. 

5.   Tighten the bolt (6). 
6.   Replace the oil cap (5). 
7.  Adjust the presser foot pressure using the adjustment 

screw (4), and then tighten the nut (3). 

 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 

4252M 

4253M 

Becomes less 

Becomes greater