Brother 431C Manual De Usuario
4. ASSEMBLY
4-18. Work clamp arm mechanism (KE-434B, 434C, 435B, 435C, 436B, 436C, 484C)
Align with the screw stop and push down gently
from above while tightening the set screw.
from above while tightening the set screw.
Y-feed lever
3431Q
1) Turn the Y-feed lever forward as far as it will go.
2) Insert the tack width regulator block assembly and the feed guide slide
2) Insert the tack width regulator block assembly and the feed guide slide
block into the grove in feed bracket guide plate R so that they face as
shown in the illustration, and then install the feed bracket assembly and
feed bracket guide plate R.
shown in the illustration, and then install the feed bracket assembly and
feed bracket guide plate R.
KE-430B, 430C series
92
Tack width regulator
Seen from below
block assy
Y-feed lever
cover
cover
Feed guide slide block
1. Feed bracket assy
3432Q
2. Feed bracket guide plate, R
3. Flat screws [2 pcs]
3) Pass the Y-feed lever cover through the slot in the arm bed, and then
insert the tack width regulator block assembly into the hole in the Y-feed
lever.
lever.
4. Screws [2 pcs]
5. X-feed lever cover
6. Spacers [2 pcs]
7. Retainer assys [2 pcs]
8. Tack length regulator block assy
9. Set screw
10. Rubber cap
5. X-feed lever cover
6. Spacers [2 pcs]
7. Retainer assys [2 pcs]
8. Tack length regulator block assy
9. Set screw
10. Rubber cap