Husqvarna C10 Manual De Usuario
49
5. Position the fabric so that the needle is
2mm (1/16 inch) in front of the area to be
darned, and then lower the presser foot
lever.
darned, and then lower the presser foot
lever.
Please Note: When lowering the
presser foot, do not push in the front of
the presser foot, otherwise the darning
will not be sewn with the correct size.
presser foot, do not push in the front of
the presser foot, otherwise the darning
will not be sewn with the correct size.
6. Pass the upper thread down through the
hole in the presser foot. Pull down the
buttonhole lever then push it back. The
buttonhole lever is positioned behind the
bracket on the buttonhole foot. Gently hold
the end of the upper thread in your left
hand, and then start sewing.
buttonhole lever then push it back. The
buttonhole lever is positioned behind the
bracket on the buttonhole foot. Gently hold
the end of the upper thread in your left
hand, and then start sewing.
Please Note: When you select any
buttonhole pattern or darning pattern,
the LCD screen will display the fi gure
“
buttonhole pattern or darning pattern,
the LCD screen will display the fi gure
“
“, to remind you to pull down the
buttonhole lever.
7. Darning stitches are sewn from the front of
the presser foot to the back, as shown.
8. If the area to be darned is too big to sew
with one darning stitch, you can sew
several times (or cross sew) to get better
sewing result.
several times (or cross sew) to get better
sewing result.