Polycom SX-50 Manual De Usuario
PN: 1725-36137-001_E.doc
13
Interface Implementation
This section describes the recommended programming to use the
Wireless Telephone System (CPM interface module or SCX-416 MCU)
with a Mitel PBX. The procedures assume:
Wireless Telephone System (CPM interface module or SCX-416 MCU)
with a Mitel PBX. The procedures assume:
•
The Mitel SX-200, SX-50, or SX-2000 system is installed and
operational in an approved configuration. See the Telephone Switch
Interface Matrix document for tested configurations.
operational in an approved configuration. See the Telephone Switch
Interface Matrix document for tested configurations.
•
A trained Mitel technician or system administrator will be on site
with the Installer to program the system.
with the Installer to program the system.
•
The SpectraLink 6000 System or SpectraLink 8000 Telephony
Gateway is installed and the handsets are available for
programming.
Gateway is installed and the handsets are available for
programming.
Set the Switch Interface Type
SpectraLink 6000 MCU
The SpectraLink 6100 Master Control Unit requires the switch
interface type to be configured using the front panel buttons. The
configuration procedures are detailed in SpectraLink 6100 MCU:
Installation and Operation.
interface type to be configured using the front panel buttons. The
configuration procedures are detailed in SpectraLink 6100 MCU:
Installation and Operation.
SpectraLink 6300 MCU
When configuring the SpectraLink 6300 MCU, the PBX interfaces are
available as sub-menu selections when defining the Interface Module
type using the SpectraLink 6300 MCU Operator’s Console. Refer to
SpectraLink 6300 MCU: Operator’s Console for details on configuring
the Interface Modules.
available as sub-menu selections when defining the Interface Module
type using the SpectraLink 6300 MCU Operator’s Console. Refer to
SpectraLink 6300 MCU: Operator’s Console for details on configuring
the Interface Modules.
SpectraLink 8000 Telephony Gateways
Connect to the SpectraLink 8000 Telephony Gateway using the serial
or modem interface. From the Main Menu, choose Gateway
or modem interface. From the Main Menu, choose Gateway
2