ONKYO C-705TX Manual De Usuario

20

STANDBY/ON button is
pressed, but power does not
come on.

Disc is loaded in the disc tray,
but playback will not begin.

No sound

Disc skipping

Search time (when moving to
a specific track) is extremely
long.

Track numbers cannot be
stored in the memory.

Noise during play

Remote controller does not
function.

• Insert the plug firmly.

• Press the R-805TX’s STANDBY/ON but-

ton. The power to the C-705TX will
be turned on.

• Load the disc with the label facing

upward.

• Clean the disc.

• Remove the disc from the disc tray, place

the CD player in a warm place and leave
the power on for about one hour.

• Replace the disc.

• Check all cable connections. (See

pages 10-12)

•

Insert all plugs firmly into jacks.

• Set switch to proper position. See your

amplifiers operating instructions for
more information.

• Clean the disc. (See page 19)

• Replace the disc.

• Place the CD player in a more stable

location.

• Clean the disc. (See page 19)

• Replace the disc.

• Load a disc into the tray.

• Use only the track numbers on the

disc.

• Turn off the TV, or move the unit far-

ther from the TV.

• Replace the batteries.

• Remote controller is possible within a

distance of approximately 5 meters
from the unit’s sensor and a detection
range of 30°.

• Operate from a different position or

remove the obstacle.

• Connect the system components

properly according to the A-905TX/R-
805TX instruction manual.

• Power cord plug is not properly con-

nected to AC outlet.

• The R-805TX’s energy save function

is enabled (when the R-805TX is con-
nected).

• Disc is in the disc tray upside down.

• Disc is dirty.

• Moisture has accumulated inside the

CD player.

• You are playing an incorrectly-re-

corded CD-R.

• Incomplete or incorrect connections.

• Improper input selector switch setting

on amplifier.

• Disc is dirty.

• Disc is scratched.

• CD player has been bumped.

• Disc is dirty.

• Disc is scratched.

• No disc in the tray.

• A track number not on the disc is

being input.

• Interference from TV

• Battery level is low.

• Your position is too far from the unit’s

remote control sensor or out of the
sensor’s detection angle.

• An obstacle exists between you and

the unit’s remote control sensor.

• The system components are not con-

nected properly.

If you have any problems with the unit, please check the troubleshooting table below first.
For any problems not covered in the table, please consult your nearest Onkyo authorized service center.