John Deere AC-CP2GS Manual De Usuario

      

Centrifugal Pump Operator's Manual 

 

                  

             13  

1.  Put unit on level surface.
2.  Run engine a few minutes to warm oil.
3.  Stop engine.
4.  Remove oil filler cap and drain plug and drain oil into container.  Do not pollute,  

dispose of waste oil properly.

5.  Install drain plug.  Fill with oil to top of threads.  Install cap.

Use oil viscosity based on the expected air temperature 
range during the period between oil changes.  

John Deere TURF-GARD

TM

 is preferred.  Also recommend-

ed is John Deere PLUS-4

®

.

Other oils may be used if they meet one or more of the 
following:

•  API Service Classification SH

•  API Service Classification SG

•  CCMC Specification G4

•  CCMC Specification G5

1.  Remove wing nut (A) and remove air cleaner cover. Push lower part of tabs (A) inward 

and through tab holders to remove cleaner cover .

2.  Remove second wing nut (B) to remove air cleaner assembly.
3.  Separate air cleaner elements. Check both elements for holes or tears. Replace if 

damaged.

4.  Wash foam element (C) in solution of household detergent and warm water.  Rinse 

thoroughly and allow to dry thoroughly.  Soak element in clean engine oil.  Squeeze 
out excess oil.
NOTE: Engine will smoke during initial start-up if too much oil is left on foam.

5.  Remove excess dirt from paper element (D) by tapping lightly on hard surface, or 

by blowing compressed air from inside the element.  Do NOT brush dirt.  Brushing 
will  force  dirt  into  element  fibers.    Replace  paper  element  after  300  hours,  or  if 
excessively dirty.

6.  Install air cleaner in reverse order as removed.