John Deere AC-CP2GS Manual De Usuario

Descargar
Página de 38
 
 
 Centrifugal Pump Operator's Manual 
  
Pre-Operation 
 
 
DO  NOT  USE  OLD  FUEL  OVER  30  DAYS.  FUEL  SHOULD  BE  CLEAN 
AND FRESH. FUEL AROUND THE BOTTOM OF DRUM CONTAINS DIRT, 
IMPURITIES  AND  WATER.  UNUSED  FUEL  IN  TANK  (IF  KEPT  MORE 
THAN 30 DAYS) MAY CAUSE ENGINE FAILURE.
 
BEFORE STARTING ENGINE, PLEASE CHECK IF ENGINE OIL IS FILLED 
TO REQUIRED LEVEL. 
2.   Make sure suction hose is connected properly.
Note: Failure to use approved non-collaps-
ible suction hose and recommended 
hose strainer at all times during op-
eration of pump will void the warranty 
of the pump and engine.
3.   Fill pump with water before use.
4.  Priming: this pump is self-priming, however it 
still requires the pump body to be filled with 
water.  Running  the  pump  without  filling  with 
water can result in mechanical seal failure.
5.  Hose connections: If the pump fails to pump 
water  in  a  short  time,  the  suction  hose 
connection could be leaking air. Stop the engine 
and  check  the  suction  hose  connection  and 
re-start the engine.
As pump is self-priming type, fill water fully from priming port into pump before run-
ning. Insufficient water can cause damage to pump. 
CAUTION  RUNNING  WITHOUT  FILLING  WITH  WATER  CAN  DAMAGE 
MECHANICAL SEAL.
WARNING THIS PUMP IS NOT INTENDED FOR USE WITH CHEMICALS OR 
FERTILIZERS.  IF  USED  FOR  APPLICATIONS  PUMPING  CHEMICALS 
OR  FERTILIZERS,  THE  2-YR  LIMITED  WARRANTY  WILL  NOT  BE 
HONORED  AS  MOST  CHEMICALS  AND  FERTILIZERS  WILL  CAUSE 
PREMATURE  CORROSION  AND  SHORTEN  THE  LIFE  OF  THE  PUMP. 
THE  PUMP  SHOULD  BE  FLUSHED  WITH  CLEAN  WATER  AFTER 
PUMPING  ANY  LIQUIDS  WHICH  MAY  BE  CONSIDERED  CAUSTIC  OR 
CORROSIVE.