Alpine IVA-D300 Manual De Usuario

• No disc is inserted.

- Insert a disc.

• Although a disc is inserted, “NO DISC” is displayed and the

unit does not start to play or eject the disc.
- Remove the disc by following these steps:

Press c for at least 3 seconds.

• Mechanism error.

1) Press c and eject the disc.

If not ejecting, consult your Alpine dealer.

2) When the error indication remains after ejecting, press c

again.
If the error indication still does not turn off after pressing
c for a few times, consult your Alpine dealer.

• Scratched disc, contaminated disc/poor recording/disc

incompatible with this unit
- Press c.
- Change the disc.

• No disc is inserted.

- Insert a disc.

• Although a disc is inserted, “NO DISC” is displayed and the

unit does not start to play or eject the disc.
- Remove the disc by following these steps:

Press c for at least 3 seconds.

• Remote control operation is not possible.

- For some discs or playing modes, certain operations are not

possible.  This is not a malfunction.

• Protective circuit is activated to high temperature.

- The indicator will disappear when the temperature returns to

within operation range.

- Leave the power OFF until the temperature decreases and

then turn the power ON again.

• PAL disc is loaded.

- Load an NTSC disc

Error displays
• Mechanical error

- Press c. After the error indication disappears, insert the disc

again. If the above-mentioned solution does not solve the
problem, consult your nearest ALPINE dealer.

MP3/WMA is not played back.
• Writing error occurred. The CD format is not compatible.
    - Make sure the CD has been written in a supported format.

Refer to “About MP3/WMA” (pages 15 and 16), then rewrite
in the format supported by this device.

Unit does operate.
• Monitor’s power is not turned on.

- Turn on the monitor’s power.

• Condensation.

- Wait a while (about 1 hour) for the condensation to dry.

No picture is produced.
• Monitor’s mode is not switched to the mode you want to see.

- Switch to the mode you want to see.

• Monitor’s parking brake lead is not connected.

- Connect the monitor’s parking brake lead and set the parking

brake.
(For details, refer to the monitor’s instructions.)

• Monitor’s parking brake is not set.

- Connect the monitor’s parking brake lead and set the parking

brake.
(For details, refer to the monitor’s instructions.)

Playback does not start.
• Disc is loaded upside-down.

- Check the disc and load it with the labeled side facing

upward.

• Disc is dirty.

- Clean the disc.

• A disc not able to playback with this unit is loaded.

- Check if the disc is able to be played back.

• Parental lock is set.

- Cancel the parental lock or change the rating level.

Picture is unclear or noisy.
• Disc is being fast-forwarded or fast-reversed.

- The picture may be slightly disturbed, but this is normal.

• Vehicle’s battery power is weak.

- Check the battery power and wiring.

(The unit may malfunction if the battery power is under 11
volts with a load applied.)

• Monitor’s fluorescent tube is worn.

- Replace the monitor’s fluorescent tube.

Image stops sometimes.
• Disc is scratched.

- Replaced with a non-scratched disc.

• Protective circuit is activated due to high temperature.

- The indicator will disappear when the temperature returns to

within operation range.

- Leave the power OFF until the temperature decreases and

then turn the power ON again.