Lenoxx Electronics CD-1492 Manual De Usuario

INTRODUCTION

Your new COMPACT DISC PLAYER WITH AM/FM STEREO CASSETTE RECORDER

is a specially designed all solid state set which, with proper care, will give you years of

trouble-free service. Please read these operating instructions carefully as they will

help you obtain maximum performance from this set. Unpack the set carefully and

place it on a level surface, away from sources of excessive heat, such as radiators.

POWER SUPPLY- 2 WAY SYSTEM

This set is designed to be operated from two different power sources as

listed below:

A. DC OPERATION

This set runs on 8 size “D” batteries. For best performance, always use heavy duty

alkaline batteries.

TO INSTALL BATTERIES

1.Remove the BATTERY DOOR by gently pushing tabs downward and outward.

NOTE: To use your set on battery power, you MUST remove the AC power cord

from BOTH the wall outlet AND the back of the set.

NOTE: Do not mix old and new batteries. Do not mix rechargeable (nickel cadmium)

and regular carbon zinc or alkaline batteries. Installation of batteries should

be done by an adult (for safety).

NOTE: The negative polarity

(side) of battery

touches the spring.

B. AC OPERATION

Plug the AC power cord into the back of the set and insert the AC PLUG into 120 Volts

AC 60Hz standard household outlet.

4

POLARIZED AC PLUG

BATTERY INDICATOR

The POWER lamp also shows you if your batteries are fresh. When this lamp

gets dim, it is time to replace the batteries.

NOTE: This cord is polarized. This means either

end of the cord will only fit ONE way into

the socket or wall outlet. If it does not fit, do

not force it, just reverse it and try again.

NOTE: If the AC power cord is plugged into the

back of the set, the set will not work on

batteries.  To operate the set on batteries,

remove the AC PLUG from the back of the

set.

IB-CD1492(AD)-WM-E-031402

2.Install 8 size “D” batteries.

NOTE: The battery compartment has 2 levels,

upper and lower. Be sure to install the

batteries as per the sketch shown

and the indication on the back of the set.

3.Replace the BATTERY DOOR.

NOTE: Old batteries may swell and leak. To

avoid damage to your set, remove the

batteries when the set is to be stored for

long periods of time or if the batteries

become exhausted (when the batteries

become weak, the POWER/BATT. lamp will

be dim; when the batteries are completely

dead, the POWER/BATT. lamp will be off).

IB-CD1492(AD)-W-E-031402.p65

3/19/02, 2:16 PM

5