3com DUA3700-0BAA04 Manual De Usuario
Distribution Rack Installation
3-5
Unit and Rack
Preparation
To prepare the CoreBuilder 7000 family ATM switch and distribution rack
for installation:
for installation:
1 Attach the mounting brackets onto the sides of the CoreBuilder 7000
family ATM switch using the mounting bracket screws (M4 x 8 Phillips).
2 Determine whether or not the distribution rack has threaded holes. If the
holes are threaded, “Mounting the CoreBuilder 7000 Family ATM
Switch” on page 3-6.
Switch” on page 3-6.
3 If the holes are not threaded, you must insert “G” clips. To determine
where to insert “G” clips, locate the top of a universal mounting hole
pattern on the left mounting rail. In the universal rail pattern, the spacing
between holes is 1/2 inch, 5/8 inch, 5/8 inch, and 1/2 inch. To find the top
of the pattern, locate the midpoint between any two holes that are
spaced half an inch apart. Figure 3-1 shows the universal mounting hole
pattern.
pattern on the left mounting rail. In the universal rail pattern, the spacing
between holes is 1/2 inch, 5/8 inch, 5/8 inch, and 1/2 inch. To find the top
of the pattern, locate the midpoint between any two holes that are
spaced half an inch apart. Figure 3-1 shows the universal mounting hole
pattern.
Figure 3-1 Universal Mounting Hole Pattern
4 From the top of the universal mounting hole pattern, insert “G” clips in
the holes designated for the unit model.
5 Repeat steps 3 and 4 for the right rail. Ensure that you start on the same
hole space.
You are now ready to mount the CoreBuilder 7000 family ATM switch
into the distribution rack.
into the distribution rack.
Top of a universal mounting
hole pattern
hole pattern
1/2-inch spacing
5/8-inch spacing
5/8-inch spacing
1/2-inch spacing
Universal mounting
hole pattern
hole pattern