Axor 10920001 Manual De Usuario

Preparation

The Waterwall requires 1/2” NPT male nipples, extend-

ing 5/8” outside the surface of the finished wall for the

hot and cold water supplies.
For proper operation of the thermostatic mixer, the hot

supply should be on the left and the cold supply should

be on the right.
Finish and seal the wall prior to installation of the

Waterwall.
Flush the supply lines thoroughly before installation.

Installation

Drill the holes for the top and bottom mounting brack-

ets, using a 6 mm bit. Install the anchors. Seal around

the anchors with waterproof sealant.
Screw the mounting brackets to the wall with the screws

provided.
Wrap the threads on the nipples with Teflon tape. Install

the elbows so that the outlets face upwards.

��

Seal the wall around the nipples and

anchors with waterproof sealant.
Failure to seal the wall can lead to

possible water damage.