Cisco Systems SF300-24PP Manual De Usuario

  • The LEDs of the corresponding RJ-45 port light to respond to the SFP 

interface traffic.

SG300-10SFP and SG300-28SFP have dedicated SFP ports. 

Their LED status and indication are the same as on the RJ-45 ports.

System LED—(Green) Lights steady when the switch is powered on, and 
flashes when booting, performing self tests, and acquiring an IP address. If 
the LED flashes Amber, the switch has detected a hardware failure.

LINK/ACT LED—(Green) Located on the left of the port. Lights steady 
when a link between the corresponding port and another device is 
detected. Flashes when the port is passing traffic. 

PoE (if present)—(Amber) Located on the right of the port. Lights steady to 
indicate that power is being supplied to a device attached to the 
corresponding port.

100M LED (if present)—(Green) Located on the right of the port. Lights 
steady when another device is connected to the port, is powered on, and a 
100 Mbps link is established between the devices. When the LED is off, the 
connection speed is under 100 Mbps or nothing is cabled to the port.

Gigabit LED (if present)—(Green) Located on the right of the port. Lights 
steady when another device is connected to the port, is powered on, and a 
1000 Mbps link is established between the devices. When the LED is off, 
the connection speed is under 1000 Mbps or nothing is cabled to the port.

SFP (if present)—(Green) Located on the right of a GE port. Lights steady 
when a connection is made through the shared port. Flashes when the port 
is passing traffic.

The switch can be reset by inserting a pin or paper clip into the reset 
opening. See 

 for 

details.

The power port and console port are located on the back panel of the 
managed switch.

Power—The Power port is where you will connect the switch to power. 
Depending on the model of switch you are using, this may be a power cord 
or a power adaptor.