Raritan Engineering MCCAT18 Manual De Usuario
Chapter 4: Advanced Operation and System Configuration
31
Function Key Description
F4
Displays the Configuration Menu.
F5
Displays the Administration Menu.
F6
Turns on the AutoScan function.
Alt+F6
Turns off the AutoScan function.
F7
Turns on the AutoSkip function.
Alt+F7
Turns off the AutoSkip function.
F8
Checks channels one by one and updates the channel status accordingly.
F12
Toggles the channel sorting between sorting by “channel number” and
sorting by “name” in the Selection Menu.
sorting by “name” in the Selection Menu.
Esc
Quits the current menu or the OSD interface.
Resetting the System
To restore all MCCAT settings back to factory defaults, follow the
procedure below. Note that this function should be performed on the
first‐tier MCCAT unit alone f yours is a two‐tier system.
procedure below. Note that this function should be performed on the
first‐tier MCCAT unit alone f yours is a two‐tier system.
1. Power OFF the MCCAT unit.
2. Press the channel number 3 button on the front panel, and then
power ON the MCCAT unit.
3. Continue to hold down the channel number 3 button until you hear
the beep sound.
Warning!! If you perform the reset function on a two‐tier system, all of
the second‐tier units will be programmed back as the first‐tier units.
Therefore, you need to programme them as the second‐tier devices
once again. For instructions on programming an MCCAT unit as a
second‐tier device, see STEP 1: Programme an MCCAT Unit as a
Second‐Tier Device (on page 33).
the second‐tier units will be programmed back as the first‐tier units.
Therefore, you need to programme them as the second‐tier devices
once again. For instructions on programming an MCCAT unit as a
second‐tier device, see STEP 1: Programme an MCCAT Unit as a
Second‐Tier Device (on page 33).