Eureka 2940-2969 Series Manual De Usuario
CAUTION: Turn off the switch and unplug
the electrical cord before periodic
maintenance.
maintenance.
How to Change Light Bulb
1. Lower handle to floor to change lightbulb.
2. Remove bottom filter cover and filter. (see page 6)
2. Remove bottom filter cover and filter. (see page 6)
3. Remove screw from lens cover.
4. Pull old light bulb out of socket.
5. Push new lightbulb into socket.
6. Replace lens cover.
7. Secure with screw.
8. Return vacuum to upright position.
5. Push new lightbulb into socket.
6. Replace lens cover.
7. Secure with screw.
8. Return vacuum to upright position.
NOTE: Use GENUINE EUREKA
replacement light bulb.
Part No. 57940-2.
7
4. Lift right end of brush roll.
5. Remove and discard belt.
6. Place new belt around motor shaft.
7. Place new belt around brush roll pulley.
5. Remove and discard belt.
6. Place new belt around motor shaft.
7. Place new belt around brush roll pulley.
8. Align left end cap with base. Push end cap securely into
place. Make sure the square on the brushroll cap is in
place.
place.
9. Pull right side of brush roll to stretch belt. Secure right end
cap into base.
IMPORTANT
10. Rotate brush roll by hand 2 full rotations to properly
position belt.
11. Place hood back on cleaner. Replace and tighten two
screws.
12. Return vacuum to upright position.
SCREW
PERIODIC MAINTENANCE
(continued)
3. Lift hood to remove.