Yamaha RX-A2010 Manual De Usuario
En
20
❑ Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit
and the speaker, and the other is for the positive (+) terminal. If the wires are colored to
prevent confusion, connect the black wire to the negative and the other wire to the positive.
and the speaker, and the other is for the positive (+) terminal. If the wires are colored to
prevent confusion, connect the black wire to the negative and the other wire to the positive.
a Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable together firmly.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
d Tighten the terminal.
Using a banana plug
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
b Insert a banana plug into the end of the terminal.
❑ Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
FR
ONT
-
+
a
a
c
c
b
b
d
d
+ (red)
– (black)
FR
ONT
+
a
a
b
b
Banana plug
(SINGLE
)
PRE OUT
CENTER
CENTER
SUR. B
ACK
SURR
UND
1
2
FRO
NT
(REA
R)
SUBW
OOFER
(FR
ONT)
Audio pin cable
1
Speaker connections
2 3 4 5 6 7 8