Yamaha RX-V861 Manual De Usuario

Press Dl / h to select the desired setting 
for “EXTRA SP ASSIGN” and then press Dn.

Extra speaker assignment   
EXTRA SP ASSIGN
Selects the function of the speakers connected to the 
EXTRA SP terminals.
Choices: FRONT B, ZONE2, PRESENCE, NONE

system (see page 38)
Select “FRONT B”.

page 91)
Select “ZONE2” to set the function of the speakers 
to the Zone 2 speakers. This unit drives the Zone 2 
speakers by using the internal amplifier.

page 12)
Select “PRESENCE” to set the function of the 
speakers to the presence speakers.

terminals
Select “NONE” to deactivate the EXTRA SP 
terminals.

If you select “ON” in “BI-AMP” (see page 96), you cannot 
select “PRESENCE” or “ZONE2” in “EXTRA SP 
ASSIGN”.

Press Dl / h to select “SETUP” and then 
press Dn.

Choices: AUTO, RELOAD, UNDO, DEFAULT
• Select “AUTO” to automatically run the entire 

“AUTO SETUP” procedure.

• Select “RELOAD” to reload the last “AUTO 

SETUP” settings and override the previous 
settings.

• Select “UNDO” to undo the last “AUTO SETUP” 

settings and restore the previous settings.

• Select “DEFAULT” to reset the “AUTO SETUP” 

parameters to the initial factory settings.

• “RELOAD” or “UNDO” is available only when you have 

previously run “AUTO SETUP” and confirmed the results.

• “RELOAD” or “UNDO” is not available when you change 

the setting of “BI-AMP” in the advanced setup (see 
page 96) or “EXTRA SP ASSIGN” in “SOUND MENU” 
(see page 72).

Press Dl / h to select the desired setting of 
“EQ”.

EQ

Parametric equalizer adjusts the level of the specified 
frequency bands. This unit automatically selects the 
crucial frequency bands for the listening room and 
adjusts the level of the selected frequency bands to 
create a cohesive sound field in the room. You can 
select the type of the parametric equalizer adjustment 
from the following choices.
Choices: NATURAL, FLAT, FRONT
• Select “NATURAL” to average out the frequency 

response of all speakers with higher frequencies 
being less emphasized. Recommended if the FLAT 
setting sounds a little harsh.

• Select “FLAT” to average the frequency response 

of all speakers. Recommended if all of your 
speakers are of similar quality.

• Select “FRONT” to adjust the frequency response 

of each speaker in accordance with the sound of 
your front speakers. Recommended if your front 
speakers are of much higher quality than your other 
speakers.

Press Dn to select “START” and then press 
D

ENTER to start the setup procedure.

This unit starts the auto setup procedure. Loud test 
tones are output from each speaker during the auto 
setup procedure. Once all items are set, the 
“AUTO:RESULT” display appears in the OSD.

• During the auto setup procedure, do not perform any 

operation on this unit.

• We recommend that you get out of the room while this unit 

is in the auto setup procedure. It takes approximately 3 
minutes for this unit to complete the auto setup procedure.