ONKYO TX-SR500E Manual De Usuario
17
Connecting the power/Turning on the AV Receiver
Before connecting
• Make sure that all the connections from pages 10 to 16 are
complete.
• Turning on the AV Receiver may cause a momentary power
surge, which might interfere with other electrical equipment
such as computers. If this happens, use a wall outlet on a
different circuit.
such as computers. If this happens, use a wall outlet on a
different circuit.
1. Connect the power cord (mains lead) to a wall
outlet (the mains).
2. (Other than USA and Canadian models only)
Press POWER to switch on the main power.
The TX-SR500/TX-SR500E enters standby mode.
The STANDBY indicator lights up.
Notes
• The TX-SR500/TX-SR500E is shipped with the main
power (POWER) switch in the on position (
_) ON.
• To switch off the main power, press the POWER switch
again.
• The buttons on the remote controller don’t operate if the
POWER switch is set to OFF.
3. Press STANDBY/ON.
The AV Receiver turns on.
The ON indicator and display on the AV Receiver’s front panel
light. At the same time, the STANDBY indicator goes off.
light. At the same time, the STANDBY indicator goes off.
Note
To turn off the AV Receiver, press STANDBY/ON. The AV
Receiver enters standby mode. Be sure to set the volume to
minimum before turning off the AV receiver.
Receiver enters standby mode. Be sure to set the volume to
minimum before turning off the AV receiver.
STANDBY indicator
STANDBY/ON
STANDBY/ON
POWER