Radio Shack 04A00 Manual De Usuario

7

Connections

 terminals for each channel (as

shown here).

To connect the
speaker wires to
the amplifier, turn
the knob on the
terminal counter-
clockwise until it
stops, insert the bare wire inside the
space between the knob and the ampli-
fier, then turn the knob clockwise until it
stops to secure it.

3. Make sure 

 is set to 

.

Use this connection only if you have high-
power speakers that can handle a power out-
put of 350 watts.

Important: For a bridged connection, do not
connect any speaker wires to the black

 terminals.

1. Connect the speaker wires to the

speaker’s positive (+) and negative (–)
terminals.

2. Connect the other end of the speaker’s

positive (+) and negative (–) wires to the
amplifier’s red 

and

 terminals (as shown

here).

Note: 

on the

amplfier is used as a negative (–) termi-
nal for a bridged connection.

3. Make sure 

 is set to

.

The amplifier’s switched AC outlet provides a
source of 120 V, 60 Hz power for audio
equipment you connect to it. 

 on the

amplifier turns both the amplifier and the au-
dio equipment connected to this outlet on or
off.

To connect the amplifier to power, plug the
attached power cord into a standard AC out-
let.

Your amplifier’s fuse (located on the amplifi-
er’s back panel) protects the amplifier from
voltage surges. If the amplifier does not work
when you press 

, check the fuse. If it

is blown, see “Replacing the Fuse” on
Page 9 to replace it.