Lyngdorf Audio SDA 2175 Manual De Usuario
7
Rear panel
Fig 2: SDA 2175 rear panel.
Mains Connector
Mains voltage to the SDA 2175 is applied via an IEC320 type connector. The supplied cable
with safety ground should be used to connect the SDA 2175 to a mains outlet.
with safety ground should be used to connect the SDA 2175 to a mains outlet.
WARNING: Connect the power input only to the AC source printed on
the label. The warranty will not cover any damage caused by connecting
to the wrong type of AC mains.
to the wrong type of AC mains.
Loudspeaker connectors
The SDA 2175 loudspeaker connectors accept banana plugs, spades or
bare wire ends up to 5 mm in diameter. Connect the wires from each
loudspeaker to each channel's + and – terminals. Do not make any other
connections to the output terminals. The loudspeaker cable is inserted
bare wire ends up to 5 mm in diameter. Connect the wires from each
loudspeaker to each channel's + and – terminals. Do not make any other
connections to the output terminals. The loudspeaker cable is inserted
into the slot in the loudspeaker terminal and the terminal is tightened
firmly.
firmly.
WARNING: Always disconnect the SDA 2175 from the mains before
changing any connections to its inputs or outputs.
changing any connections to its inputs or outputs.
When the SDA 2175 is operating, there is 35V DC on its output terminals
with reference to ground.
with reference to ground.