Classe Audio CAP-2100 Manual De Usuario

12

Standby button & LED indicator
Th

  e front panel Standby button will toggle the integrated amplifi er 

between operate, its fully operational state, and a standby mode that leaves 
the integrated amplifi er off , yet ready to respond to system commands via 
any of the supported control options (e.g. IR input, DC trigger, CAN-Bus, 
or RS-232). 

Th

  e current state of the integrated amplifi er is indicated by the LED on 

the standby button on the front panel. When the unit is powered and 
switched on, the state of this LED indicates the following:

• on 

=   standby

• fl ashing (on power-up) = 

 

• off  

=  

• on (dim) = 

 

• fl ashing (after power-up) = 

 AC mains voltage out of range

If you are planning not to use the integrated amplifi er for an extended 
period of time, e.g. vacation or other travel, we suggest you disconnect it 
from the AC mains. Please be certain that the integrated amplifi er is in 
standby prior to disconnecting it from the AC mains.

Also, it is a good practice to physically disconnect any and all valuable 
electronics from the AC mains during electrical storms, as a lightning strike 
anywhere near your home can put a tremendous surge on the AC mains 
that can damage any piece of electronics, no matter how well designed 
and protected. Th

  e best protection in the case of severe electrical storms is 

simply to remove the electronics from any connection with the power grid.