Classe Audio CAP-2100 Manual De Usuario

38

In general, you should refer any service problems to your Classé dealer. Before 
contacting your dealer, check to see if the problem is listed here. If it is, try the 
suggested solutions. If none of these solves the problem, contact your Classé 
dealer.

•  Adjust the volume control to a moderate level (one that should 

be audible but is not excessive).

•  Make sure the source component for which the input has been 

selected is switched on and is out of its standby mode.

•  Make sure the proper input has been selected for the source 

being used.

•  Check that the integrated amplifi er is not in mute mode. Th

 is is 

indicated by the operational menu icon in the form of a speaker 
with a bar through it. Press Mute to disengage.

•  Check if the tape monitor is enabled. If it is engaged and the 

recorder is off , you will not hear the selected source. Disengage 
by pressing Tape, unless you wish to monitor the recording.

•  If the problem occurs only with a particular input, check the 

interconnect cables between that source and the integrated 
amplifi er.

•  If the problem occurs with all inputs, check the speaker wires for 

secure connections.

•  Ensure the integrated amplifi er is plugged into the AC mains and 

switched on, and that the AC mains are operating normally. Th

 e 

unit will automatically attempt to protect itself from improper 
AC mains voltages by not powering up.

•  If your integrated amplifi er was plugged in properly, try the 

following: put it in standby, switch off  the main power switch in 
the back, and unplug the unit for at least thirty seconds before 
trying to power it up again. (Sometimes a brownout of short-term 
loss of power might require a restart.)

•  If none of these solutions work, please consult your Classé dealer 

for assistance. Never attempt to replace an internal fuse. Th

 ere 

are no user-serviceable parts inside your unit.