Classe Audio CP-700 Manual De Usuario

12

MENU

CP-700

MUTE

/0 1 23

4

Standby button & LED indicator
Th

  e front panel Standby button will toggle the preamplifi er between 

operate, its fully operational state, and a standby mode that leaves the 
preamplifi er off , yet ready to respond to system commands via any of the 
supported control options (e.g. IR input, DC trigger, CAN-Bus, or 
RS-232). 

Th

  e current state of the preamplifi er is indicated by the LED indicator in 

the center of the standby button. When the unit is powered and switched 
on, the state of this LED indicates the following:

• on 

=   standby

• fl ashing (on power-up) = 

 

• off  

=  

• on (dim) = 

 

• fl ashing (after power-up) = 

 AC mains voltage out of range

If you are planning not to use the preamplifi er for an extended period of 
time, e.g. vacation or other travel, we suggest you disconnect it from the 
AC mains. Please be certain that the preamplifi er is turned off  prior to 
disconnecting it from the AC mains.

Also, it is a good practice to physically disconnect any and all valuable 
electronics from the AC mains during electrical storms, as a lightning strike 
anywhere near your home can put a tremendous surge on the AC mains 
that can damage any piece of electronic equipment, no matter how well 
designed and protected. Th

  e best protection in the case of severe electrical 

storms is simply to remove the electronics from any connection with the 
power grid.