EAW KF730 Manual De Usuario

The horizontal pattern also features “soft shoulders” that provide consistent frequency response 
to well beyond the nominal -6 dB points. These soft shoulders can provide up to 150° of “usable” 
horizontal coverage, albeit at somewhat reduced level. This off-axis performance also provides 
good acoustic integration with side-fill arrays. In some cases, these shoulders may be sufficient 
for side-fill purposes. 
 
4.2.4 

KF730 side fill arrays can be hung adjacent to the mains, extending the coverage to over 180° for 
wrap-around audience coverage. 
  

Normally, a ground-stacked KF730 main array is used where suspension is not possible, too 
difficult, or too time consuming. Additional uses are as stage side fills and audience front fill. 
 
Both KF730s and SB730s may be ground-stacked alone or in combination. In combination, 
always stack the KF730s on top of the SB730s. The recommended minimum and maximum array 
quantities are: 
 

KF730 alone 

2 

6 

SB730 alone 

1 

4 

KF730 / SB730 

2/1 

6 / 4 

 
WARNING: Ground-stacked arrays, especially the maximum recommended arrays, requires 
assembly by personnel qualified to ensure adequate stability from tip over for the particular 
application. See Section 6.8 for correct array assembly. Mechanical assistance will be required to 
lift and position enclosures for arrays taller than approximately 5 feet. 
 

Although the impressive low frequency performance of KF730 Series arrays allows them to be 
used without subwoofers for some events, subwoofers will normally be used for live musical 
performances. The recommended subwoofer is EAW’s SB730, specifically designed to 
complement KF730 line arrays.  
 
NOTE: Bass performance is often highly program or venue-dependent, as well as subjective as 
to quantity and quality. For this reason the type, quantity, and disposition of subwoofers may vary 
considerably with the application. The quantity recommendations below are for general purposes, 
providing a balanced system for most music applications. Quantities may need to be adjusted up 
or down for specific situations. 
 
4.4.2 SB730 

SB730 subwoofers are designed to complement the KF730 loudspeakers to both extend the low 
frequency response and provide more output for the upper low frequencies. The SB730 
subwoofers may either be ground stacked, flown as part of a KF730 array, or flown separately 
alongside a KF730 array. 
 
A general recommendation is to use KF730s and SB730s in a ratio of three KF730s to two 
SB730s. 
  
4.4.3 Suspending 

The SB730 enclosure rigging is designed to directly couple to a KF730 Fly-Bar and KF730 
enclosures. As such, the SB730 can be rigged seamlessly with KF730s.