Yamaha DSP-Z11 Manual De Usuario

After the connection, turn on this unit and then set the assignment of 
the speaker terminals and other zone parameters.

■ Assigning the zone speakers
Use “Zone SP Assign” to set the zone that each speaker terminal are 
used for.

Press I

MENU on the remote control.

The top GUI menu appears in the video monitor.

Press 9k / n repeatedly to select “Manual Setup” 
and then 9h.

Press 9k / n repeatedly to select “Multi Zone” and 
then 9h.
“Multi Zone” menu appears in the GUI screen.

Press9k / n repeatedly to select “Zone SP Assign” 
and then press 9h.
Following display appears in the GUI screen.

Press 9k / n repeatedly to select the desired 
speaker terminals and then 9l / h repeatedly to 
select the desired zone you want to use the speaker 
connected to the selected speaker terminals.
When “PREAMP MODE” in the advanced setup is set to 
“OFF” (see page 120), “FRONT”, “CENTER”, “SUR.” and 
“S.BACK” are fixed to “M” (the main zone).
To make the system of the example (see page 111), set “Zone 
SP Assign” as follows:

F.PRNS: FRONT PRESENCE speaker terminals

EXTRA: EXTRA SP speaker terminals

FRONT: FRONT A speaker terminals

CENTER: CENTER speaker terminals

SUR.: SURROUND speaker terminals

S.BACK: SUR.BACK speaker terminals

R.PRNS: REAR PRESENCE speaker terminals

Once you have finished the settings of all the 
speaker terminals, press 9

ENTER to confirm the 

setting and exit from the “Zone SP Assign” screen.

Set other zone parameters appropriately.
See pages 91 and 92 for details.

Once you have finished the settings of the zone 
parameters, press I

MENU to exit the GUI menu.

You can select the zone you want to control by using the control 
buttons on the front panel or on the remote control. 

■ Basic operation

Press K

ZONE 2, KZONE 3, or KZONE 4 on the 

Press K

ZONE CONTROLS on the front panel 

Each time you press KZONE CONTROLS, the front panel 
display changes as shown below, and the indicator for the 
currently selected zone flashes for approximately 10 seconds. 
However, no indicator flashes when the main zone is selected.

ZONE2
Controls the Zone 2 functions.

ZONE3
Controls the Zone 3 functions.

ZONE4
Controls the Zone 4 functions.

y

• You must complete this step within 10 seconds while the selected zone flashes 

in the front panel display. Otherwise, the currently selected zone mode is 
automatically canceled. In this case, press 

KZONE CONTROLS again.

• The initial setting is ZONE2 when Zone 2, Zone 3, and Zone 4 are turned on.

Exit: ENTER

M: Main zone

2: Zone 2
3: Zone 3
4: Zone 4

PREAMP MODE
When “PREAMP MODE” in the advanced setup is set to “ON” 
(see page 120), you can assign all the speaker terminals of this 
unit to Zone 2, Zone 3, or Zone 4. The audio signals for the main 
zone are only output at the PRE OUT jacks.