Yamaha DSP-Z11 Manual De Usuario
Saving and recalling the system settings (System Memory)
98
En
■ Saved parameters for the main zone
The groups of the system parameters indicated in bold are the
groups that is saved in the initial setting.
The groups of the system parameters indicated in bold are the
groups that is saved in the initial setting.
* The playing status of the network/USB sources (selected radio station, etc.) is also
saved.
■ Saved parameters for Zone 2, Zone 3, or Zone 4
* The playing status of the network/USB sources (selected radio station,
etc.) is also saved.
■ Loading by the 7SYSTEM MEMORY buttons
You can recall the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding 7SYSTEM MEMORY
buttons.
You can recall the system settings stored in “Memory1” to
“Memory4” by pressing the corresponding 7SYSTEM MEMORY
buttons.
y
To recall the system settings for Zone 2, Zone 3, or Zone 4, press HZONE on the
remote control repeatedly to select the operation zone setting of the remote control in
advance. You can recall the system settings for the selected zone only when the zone is
turned on.
remote control repeatedly to select the operation zone setting of the remote control in
advance. You can recall the system settings for the selected zone only when the zone is
turned on.
1
Press one of the 7
SYSTEM MEMORY buttons on
the remote control to select the desired memory
number.
“MEMORY 1 LOAD” (example) appears in the front panel
display.
number.
“MEMORY 1 LOAD” (example) appears in the front panel
display.
y
“EMPTY” appears in the menu screen if no system settings are stored in the
selected memory number.
selected memory number.
2
Press the selected 7
SYSTEM MEMORY button
once more to confirm the selection.
This unit loads the settings stored in the selected memory
number.
This unit loads the settings stored in the selected memory
number.
■ Loading by the GUI menu operation
1
Press I
MENU on the remote control.
The top menu appears in the video monitor.
2
Press 9k / n repeatedly to select “System Memory”
and then press 9h.
The “System Memory” menu appears in the video monitor.
and then press 9h.
The “System Memory” menu appears in the video monitor.
3
Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, you select “Main” (main zone). The
list of the memory number appears in the video monitor.
and then press 9h.
In the following example, you select “Main” (main zone). The
list of the memory number appears in the video monitor.
Group
Parameters
Page
*
Input source
—
Pure Direct on/off
EXTD SUR. setting
CINEMA DSP HD³ ON/OFF
Volume level
Selected front speaker set (A and/or B)
Note
Parameter
Descriptions
Page
Input source *
Volume level
Tone control settings
Note
Loading the stored system settings
• Before performing the following operations, set the operation mode selector on
the remote control to F AMP.
• This unit overwrites the stored settings to the current settings of this unit. If you
do not want to erase the current settings, save the current settings to any System
Memory number in advance.
Memory number in advance.
Main Load
Main Save
Main Rename
Memory1
Memory2
Memory3