JVC NX-DV3 Manual De Usuario

Introduction

(Continued)

Setting Up the Unit

■Pattern 2

As shown in the

diagram, detach the

foot seals (supplied)

from the backing.

Attach four foot seals to the

bottom of each surround speaker.

■Pattern 3

• Place the surround speakers slightly behind the

listening point.

In this case, change the surround speaker cord

to the 10 meter long one (supplied).

• With this setting, select "R" in "Setting the

Speaker Position" (

page 10).

• While the speaker position is set to "R", the

speaker setting icon is added to the initial setting
screen (

page 42).

Attaching the Foot Seals to

the Surround Speakers to

Prevent Them from Slipping

JVC logo is placed

outside.

Left speaker
(SP-NXDV3F)

Right speaker
(SP-NXDV3F)

Surround
speaker
(SP-NX
DV3S)

Center unit
(CA-NXDV3)

TV stand
(not supplied)

Listening Point

• Place the surround speakers close to the front

speaker.

• With this setting, select "F2" in "Setting the

Speaker Position" (

page 10).

• When placing the

unit vertically

• When placing the

unit horizontally

Label

Left speaker
(SP-NXDV3F)

Right speaker
(SP-NXDV3F)

Center unit
(CA-NXDV3)

JVC logo is placed

outside.

TV stand (not supplied)

Listening Point

Surround speakers
(SP-NXDV3S)

White
switch

Bronze
wire -
connect it
to positive
side (+).

White
switch

Silver wire
- connect it
to negative
side (–).

Pull out the wire while
holding down the white
switch on the plug.

Hold down the white
switch on the plug and
connect the 10 meter
long cord.

(+)

(–)

Black line

NX-DV3[UJ].book 9 ページ２００４年１２月２８日　火曜日　午後２時３７分