Philips AZ 1025 Manual De Usuario

11

1. Tune to your desired station, following steps 1-3 under ‘Tuning

to radio stations’.
™ If the frequency is already stored in the memory, the preset

number will be displayed.

2. Press PROG to activate programming.

™

flashes in the display.

3. Press the PRESET control (up or down) to allocate a preset

station number from 1 to 29.

4. Press PROG again to confirm the setting.
5. Repeat steps 1-4 to store all other presets.
• You can clear a preset number by storing another frequency in

its place.

To deactivate programming mode
If during programming you decide not to program a station, adjust
the CD TUNER TAPE/

OFF

slider to CD or TAPE/

OFF

position.

Tuning to preset stations
Press the PRESET 

4, 3 control (down, up) until the desired

number is shown.

: when the CD door is opened.

- Total track number and playing time: in stop mode.

: when no disc is inserted.

: error in CD operation or with the CD 

(see ‘Troubleshooting’).
– Current track number and elapsed playing time:

during CD playback.

– Elapsed playing time freezes and flashes:

in PAUSE position.

–

) modes: when the respective mode is

activated.

: program mode is active.

: appears briefly and the selected track number (1-20) when

you program.

FULL: program memory full.

:

– when you cancel a CD program; you press PROG for more

than two seconds but no track has been selected.

:

– you press PROG but no track has been selected.

AZ 1025 /17  

page

11

XP AZ 1025/17  19-09-2000 13:02  Pagina 11