Curtis RCD544 Manual De Usuario

Descargar
Página de 10
Insert two(2) 
“AAA”/1.5V batteries following the polarity as indicated in the compartment to the right. 
Alkaline batteries are recommended for long using time. 
Note: when planning not to use the remote control for a long time. Remove the batteries in order to avoid 
the electrolyte leakage.   
 
UNIT POWER SUPPLY ( mains 120V/60Hz) 
Connect the power cable plug to the (120V/60Hz) wall outlet. 
Warning: 
Before using the unit. Check that the local mains supply is compatible with the HI-FI System (120V 60Hz) 
Do not plug or unplug the power cable when your hands wet. 
When planning not to use this unit for long periods of time(i.e, Vacation etc.) disconnect the plug from the 
wall outlet. 
When disconnecting the power cord from the wall outlet , grasp the plug; do not pull the cord in order to 
avoid shock risks caused by the damaged cable. 
 
HEADPHONE JACK 
This unit will accept stereo headphones with a 
Ф  3.5mm plug. Before connecting the headphones set 
the volume to minimum level as not to damage your ears or the headphones. Connect the headphones to the 
headphones jack. The speakers will be automatically disconnected. 
Warning: Prolonged exposure to high sound levels may permanently damage your hearing. You may 
not hear some warning sound while wearing these headphones. 
 
VOLUME 
Press VOL- or VOL+ to adjust the volume to the desired level. 
VOL- : to decrease the volume; 
VOL+: to increase the volume. 
 
LISTENING TO THE RADIO 
1. Press CD/RADIO FUNCTION SWITCH up to RADIO position. 
2.  Press STANDBY/ON button to turn on the unit. 
3. Press the Band (AM/FM) Button to select AM or FM. 
4. Turn TUNING Knob to tune in desired Radio station. 
5. 
To turn off Radio, Press 
STANDBY/On
 Button to turn off the unit.
 
Note: While in the Radio Mode, the display will indicate as Frequency.   
 
ANTENNAS 
An AM antenna is built outside the unit. 
For better reception , FM wire antenna shall be fully untied and adjusted well   
 
CLOCK SETTING 
In power off (standby) mode: 
Press and hold Time button to set the clock 
 
7