Philips HTL2151F7 Manual De Usuario

English

7 Troubleshooting

Warning

•

Risk of electric shock. Never remove the casing of the

product.

To keep the warranty valid, never try to repair

the product yourself.

If you have problems using this product, check

the following points before you request service.

If you still have a problem, get support at www.

philips.com/support.

Main unit

The buttons on the SoundBar do not work.

• Disconnect the SoundBar from the power

supply for a few minutes, then reconnect.

Sound

No sound from SoundBar speakers.

• Connect the audio cable from your

SoundBar to your TV or other devices.

• Reset your SoundBar to its factory settings.

• On the remote control, select the correct

audio input.

• Make sure that the SoundBar is not muted.
Distorted sound or echo.

• If you play audio from the TV through the

SoundBar, make sure that the TV is muted.

8 Notice

This section contains the legal and trademark

notices.

Notice of compliance

This set complies with the FCC rules, Part

15. Operation is subject to the following two

conditions:
a

This device may not cause harmful

interference, and

This device must accept any interference

received, including interference that may

cause undesired operation.

FCC rules

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses and can radiate radio frequency energy

and, if not installed and used in accordance

with the instruction manual, may cause harmful

interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception,

which can be determined by turning the

equipment off and on, the user is encouraged

to try to correct the interference by one or

more of the following measures:
• Relocate the receiving antenna.

• Increase the separation between

equipment and receiver.

• Connect the equipment into an outlet on

a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.