Crestron electronic C2N-VEQ4 Manual De Usuario

Cresnet 4-Channel Digital Volume Control 

Crestron C2N-VEQ4

•  Cresnet 4-Channel Digital Volume Control: C2N-VEQ4 

balanced/unbalanced output (OUT) ports to an amplifier. Each channel includes a 
muting relay with 100 dB attenuation.  

Use this chassis screw to ground the unit to the amplifier and audio source common 
grounds.  

This 4-pin network connector is used to connect the C2N-VEQ4 module to the 
Cresnet system. Data and power for the C2N-VEQ4 are provided via the connection. 
Refer to “Network Wiring” on page 7. 

There are six LED indicators located on the front panel of the C2N-VEQ4. Refer to 
the illustration below and descriptions that follow.  

 

This green LED illuminates when power is supplied to the C2N-VEQ4. 

This yellow LED illuminates when communication between the control system and 
the C2N-VEQ4 is established (the unit is polled on the network). Illumination 
indicates that the program currently loaded has a network device defined at the same 
ID as the C2N-VEQ4. The LED flashes when communication with the processor 
occurs. 

These red LEDs illuminate only when there is activity on any of the four channels. 
Activity includes any change in volume, tone (bass, treble), mixer, or equalization 
parameters. Once the command is completed, the related LED(s) go out.  

The C2N-VEQ4 is TSID ready. The SETUP pushbutton and its associated LED are 
located on the rear panel and are used for setup of the unit’s network ID during the 
initial configuration of a Cresnet

®

 system or when the device is being added/replaced. 

Refer to “Method B (Touch Settable IDs)” on page 9

for detailed information.