Cardo G4 Manual De Usuario

3. Adjust the Helmet Clamp’s location on the Helmet so that the 

microphone is located opposite the center of 

your mouth. You may need to reposition the 

Clamp repeatedly until you identify the best 

spot. (Be sure to clean the selected area prior 

to the gluing process). 

4. Use the pre-moistened Towlette to clean the helmet area where 

you want to install the Glue Plate. Allow to dry thoroughly.

5. Peel the foil cover from the Glue Plates’ adhesive pad. 
6. Place the Glue Plate into position according to #3. Press firmly 

15 seconds on all 3 parts of the Glue Plate.

7. The adhesive pad bonds to full strength over the next 24 

hours. Therefore it is recommended to not use the headset 

during this 24 hour period.

8. Fasten the Clamp to the Glue Plate using the Allen screws that 

were previously removed.

microphone, please proceed as follows: 

If you are using the corded microphone version, you must first make 

sure your helmet clamp is attached to your 

helmet as described in previous section (5.1). 

Clean the exact spot on the internal padding of 

the helmet, opposite your mouth, where the 

microphone will be placed.
a. Peel the foil cover from the adhesive Velcro 

pad and place the Velcro pad on the chosen 

location opposite your mouth.

b. Attach the microphone to the Velcro, as shown in photo.
c. When done, tighten the screws of the clamp

The microphone must be positioned in 

front of the center of your mouth as 

detailed above.

Attach the speakers to the Velcro inside 

your helmet, opposite your ears (short 

speaker cord for left ear & long speaker 

cord for right ear). Use the supplied 

Velcro pads if needed.
Using two speakers inside the 

helmet may be prohibited in 

certain jurisdictions. If this is the 

case, you should tuck away the 

long corded speaker underneath 

the helmet padding as follows: 

Lead the speaker cord [B] 

alongside the rim of the 

padding to the right side and 

then back to the left side, near 

speaker [A]. Then place the 

speaker [B] underneath the 

padding.