JVC GET0483-001A Manual De Usuario
Set “L/O MODE” to “SUB. W”
(See page 15 of the INSTRUCTIONS.)
(See page 15 of the INSTRUCTIONS.)
Remote lead (blue with white stripe)
To the remote lead of other equipment
or automatic antenna if any
or automatic antenna if any
Y-connector
*
1
Front speakers
Subwoofer
Set “L/O MODE” to “REAR”
(See page 15 of the
INSTRUCTIONS.)
(See page 15 of the
INSTRUCTIONS.)
JVC Amplifier
JVC Amplifier
Rear speakers
or
Remote lead
Remote lead
2
Purple
Front speaker (left)
To the remote lead of other
equipment or automatic antenna if
any (200 mA max.)
equipment or automatic antenna if
any (200 mA max.)
Blue with white
stripe
stripe
Red
To an accessory terminal in
the fuse block
the fuse block
To a live terminal in the
fuse block connecting to the
car battery (bypassing the
ignition switch) (constant
12 V)
fuse block connecting to the
car battery (bypassing the
ignition switch) (constant
12 V)
Yellow
*
2
To metallic body or
chassis of the car
chassis of the car
Black
Ignition switch
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power cannot be
turned on.
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place not coated with paint (if
coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4
Signal cord (not supplied for this unit).
15 A fuse
Fuse block
Rear speaker (left)
Rear speaker (right)
Front speaker (right)
White with black stripe
Rear ground terminal
Antenna terminal
Gray with black stripe
Green
Gray
Green with black stripe
Purple with black stripe
White
ELECTRICAL CONNECTIONS
Typical connections
Connecting the external amplifiers and/or subwoofer
Make sure to disconnect the battery’s negative terminal.
• Be sure to ground this unit to the car’s chassis again after installation.
Note:
It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω).
If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 15 of the INSTRUCTIONS).
If the maximum power is less than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 15 of the INSTRUCTIONS).
Heat sink
High
Connect only the front speakers if your
speaker system is two-speaker system.
speaker system is two-speaker system.
PRECAUTIONS on power supply and speaker connections
Connecting an Apple iPod
iPod connector
You can connect an iPod to this unit using the supplied direct connection cable for iPod.
Apple iPod (separately purchased)
Direct connection cable for iPod (supplied)
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
Rear line out
Install_EN_KD-S35[J]_1.indd 2
Install_EN_KD-S35[J]_1.indd 2
6/5/08 4:41:36 PM
6/5/08 4:41:36 PM