Philips CEM3100 Manual De Usuario

3 Get started

Caution

•

Use the controls only as stated in this user manual.

Always follow the instructions in this chapter in

sequence.

If you contact Philips, you will be asked for the

model and serial number of your apparatus. The

model number and serial number are on the

bottom of your apparatus. Write the numbers

here:

Model No. __________________________

Serial No. ___________________________

Install the car audio

These instructions are for a typical installation.

However, if your car has different requirements,

make the corresponding adjustment. If you have

any questions regarding installation kits, consult

your Philips car audio dealer.

Caution

•

This unit is designed for negative ground (earth) 12 V

DC operation only.

•

Always install this unit in the car dashboard. Other

locations can be dangerous as the rear of the unit heats

up during use.

•

To avoid short-circuit: before you connect, ensure that

the ignition is off.

•

Ensure that you connect the yellow and red power

supply leads after all other leads are connected.

•

Ensure that all loose leads are insulated with electrical

tape.

•

Ensure that the leads do not get caught under screws

orin parts that will move (e.g. seat rail).

•

Ensure that all ground (earth) leads are run to a

common ground (earth) point.

•

Use only the supplied mounting hardware for a safe

and secure installation.

•

Improper fuses can cause damage or fire. When you

need to change the fuse, consult a professional.

Note on the power supply lead (yellow)

• When you connect other devices to this

apparatus, ensure that the rating of the car

circuit is higher than the total fuse value of

all the connected devices.

Notes on speaker connection

• Never connect speaker wires to the metal

body or chassis of the car.

• Never connect speaker wires with stripes

to one another.

Connection: for cars with ISO

connectors

Caution

•

Ensure that all loose leads are insulated with electrical

tape.

Note

•

Consult a professional to connect CEM3100 as

instructed below.

•

The ISO male connectors are not supplied.

Connect the male connector to the unit.

Check the car's wiring carefully and

connect them to the the male connector.

Note

•

Risk of danger! Please consult a professional to perform

the below steps!