Classe Audio SSP-800 Manual De Usuario

46

Th

 e Levels menu allows you to adjust the output levels of the speakers. An SPL 

meter should be used from the primary seating position to ensure that each 
speaker delivers the same sound pressure from a given test noise audio signal. 
Touch the Noise Seq button to activate the noise generator; the top of the menu 
now states “Levels Noise: L” – indicating that the test noise is being generated 
on the front left speaker. Th

  e test noise automatically moves to each of the 

available speakers, as indicated by the menu title, and continues to rotate around 
the room until the Noise Seq button is touched again.

To modify the actual levels, touch the speaker you want to update and then 
adjust the level using the increase and decrease buttons. Set the SPL meter to 
“C” weighting and Slow response. Each speaker level should be adjusted until 
the SPL meter reads 75dB at your main listening position.

in use Th

  is button identifi es active confi guration. If the In Use button is highlighted, 

then the Confi guration is active. If the In Use button is NOT highlighted, then 
the confi guration is considered inactive and is not available for selection in the 
Input Setup menu or in the Home page Control section.

speakers Th

  e Speakers confi guration page identifi es which speakers are active for each 

confi guration, as well as the crossover level for each speaker. Th

 e Auxiliary 

channels can also be confi gured through this menu.

First, touch the Speaker Confi g button to set up the 7.1-channel speaker 
confi gurations. Th

  en we will discuss the Auxiliary channel setups.