Panasonic TH-L32C3T Manual De Usuario

Frequently Asked

Questions

Problem

Actions

Screen

Chaotic image, noisy

●

Change the setting of [P-NR] in the Picture Menu (to remove noise).

(p. 21)

●

Check nearby electrical products (car, motorcycle, fluorescent lamp).

No image can be
displayed

●

Is [Colour] or [Contrast] in the Picture Menu set to the minimum?

(p. 21)

Blurry or distorted
image
(no sound or low
volume)

●

Reset channels (p. 28)

Unusual image is
displayed

●

Turn the TV Off with Mains power On / Off switch, then turn it On
again.

Sound

No sound is produced

●

Is “Sound Mute” active? (p. 11)

●

Is the volume set to the minimum?

Sound level is low or
sound is distorted

●

Sound signal reception may be deteriorated.

●

Set [MPX] in the Sound Menu to [Mono] (p. 24)

HDMI

Sound is unusual

●

Set the sound setting of the connected equipment to “2ch L.PCM”.

●

Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu. (p. 24)

●

If digital sound connection has a problem, select analogue sound
connection. (p. 51)

Pictures from external
equipment are unusual
when the equipment is
connected via HDMI

●

Check that the HDMI cable is connected properly. (p. 41, 47 - 49)

●

Turn the TV and equipment Off, then turn them On again.

●

Check the input signal from the equipment. (p. 52)

●

Use an equipment compliant with EIA/CEA-861/861B.

Other

The TV goes into
Standby mode

●

Auto power standby function is activated.

●

The TV enters Standby mode about 30 minutes after analogue
broadcasting ends.

The remote control
does not work or is
intermittent

●

Are the batteries installed correctly? (p. 8)

●

Has the TV been switched On?

●

Point the remote control directly at the front of the TV
(within about 7 m and a 30 degree angle from the front of the TV).

●

Place the TV away from sunshine and do not let other sources of
bright light to shine on the TV’s remote control signal receiver.

TH_L32C3KMTX_EN.indd 57

3/17/2011 3:46:11 PM