Marantz PM-11S3 Manual De Usuario

20

ENGLISH

With the Auto standby mode ON, this unit will automatically enter the standby mode after 

about 30 continuous minutes of no output from the selected input source.

• Auto standby mode is switched between On and Off with each press of the button.

On

(Factory default)

Off

• If the mode is set to off, the display shows “AUTO STBY OFF”.

• This unit will automatically enter standby mode after about continuous 30 minutes in the 

following conditions.

• No operation performed on the remote control.

• No operation of this unit.

• The display will show the remaining time for three minutes before the units enters standby 

mode.

• In F.C.B.S. connection, only the ID 1 master unit activates Auto standby mode. If the ID 1 

master unit is operated with no audio input, set the Auto standby mode to OFF. 

When you use this unit connected to marantz audio components, it sends control signals to 

operate each component.

n Connection

Use the remote connection cable (supplied with a marantz audio component you want to 

connect) to connect the REMOTE CONTROL OUT terminal of this unit to the REMOTE 

CONTROL IN terminal of the component to be connected.

n Setting

Set the remote control switch located on the rear panel of the connected audio component to 

“EXTERNAL” or “EXT.” to use this feature.

• This setting will disable remote sensor reception of the connected audio component.

• To operate the connected audio component, point the remote control at the remote sensor 

of this unit.

• To use the system control to this unit via the connected device, make the connection following 

the instructions supplied with the connected device.

REMOTE CONTROL

IN

OUT

RC OUT

1.PM-11S3U_ENG_0521.indd   20

2012/05/21   19:03:36