Parrot MKi9200 Manual De Usuario
7
Install
ing the kit‟s power cable
Note :
In order to check the wiring, connect the screen before placing it on the dashboard.
Refer to your car stereo‟s wiring diagram.
The red wire of the kit‟s cable must correspond to the constant +12V supply, the orange
wire to the ignition +12V and the black wire to ground. Check that the orange wire is not
connected to the constant
wire to the ignition +12V and the black wire to ground. Check that the orange wire is not
connected to the constant
+12V supply, as you could run down the vehicle‟s battery.
Note
:
On some vehicles, there is no ignition +12V on the vehicle’s connectors. You must therefore
connect the orange power supply wire to the fuse box or another ignition power source.
Checking the wiring
To perform the installation check, turn the ignition on then off once the Parrot MKi9200 is
installed: the message “Goodbye!” must be displayed.
installed: the message “Goodbye!” must be displayed.
If it is not the case, it is necessary to inverse the positions of the red and orange wires.
Indeed, the red wire of the power cable must be connected to the permanent 12V, the
orange wire to the 12V ignition and the black wire to the ground. This can be done simply
by reversing both fuse holders located on the Parrot wiring.
Indeed, the red wire of the power cable must be connected to the permanent 12V, the
orange wire to the 12V ignition and the black wire to the ground. This can be done simply
by reversing both fuse holders located on the Parrot wiring.
Installing the audio connectors
Installing the music
cable
cable
Connect the music cable to the electronic box and place the USB /
iPod / Jack connectors into the glove box, the central console or the
parcel tray depending on the configuration of your dashboard. Make
sure that the cable is not pinched.
iPod / Jack connectors into the glove box, the central console or the
parcel tray depending on the configuration of your dashboard. Make
sure that the cable is not pinched.
Note :
Use the provided protection cap to protect the connectors.
Installing the music
cable grommet
system
cable grommet
system
The music cable grommet system allows you to adjust the cable length
while reducing its wear.
while reducing its wear.
1. Drill a 20 mm hole in your dashboard (glove compartment or parcel
tray).
2. Insert manually two flexible arms of the grommet system.
3. Use a flat screwdriver in order to insert the last two arms.
> You can now connect your music cable to the bluebox
.