Faber M1400 Manual De Usuario

Installing the Genie Camera  •  23 

The following LED sequence occurs when the Genie is powered up connected to a network with installed Genie 
Framework software.  

power connected

waiting for IP

IP assigned

application

connected

 

The Genie IP (Internet Protocol) Configuration sequence to assign an IP address is executed automatically on 
camera power-up or when connected to a network. As a GigE Vision compliant device, Genie attempts to assign an 
IP address as follows.  

For any GigE Vision device, the IP configuration protocol sequence is: 

•  Persistent IP (if enabled) 
•  DHCP (if a DHCP server is present) 
•  Link-Local Address (always enabled) 

The factory defaults for Genie is Persistent IP disabled and DHCP enabled with LLA always enabled as per the 
GigE Vision specification. For additional information see 

. 

Once the Genie is assigned an IP address (its Status LED is steady blue) the GigE server tray icon will not have a 
red X through it, indicating that the Genie device was found. It might take a few seconds for the GigE Server to 
refresh its state after the Genie has obtained an IP address.  

 

Right-click the GigE Server tray icon to open the following menu.  

 

Click on Status to open a window listing all devices connected to the host system. Each GigE device is listed by 
name along with important information such as the assigned IP address and device MAC address. The screen shot 
below shows a connected Genie with no networking problems.