Faber M1600 Manual De Usuario

Installing the Genie Camera  •  21 

Connect a power supply to the Genie camera and an Ethernet cable from the Genie to the host computer. Once 
communication with the host computer is started the automatic IP configuration sequence will assign an LLA IP 
address as described in section 

"

" on page 23

, or a DHCP IP address if a DHCP 

server is present on your network. The factory defaults for Genie is Persistent IP disabled and DHCP enabled with 
LLA always enabled as per the GigE Vision specification. For additional information see 

"

" on page 77

. See the next section 

"

" on page 21

 for an overview of the Genie interfaces.  

The Genie has only two connectors:  
•  A single RJ45 Ethernet connector for control and video data transmitted to/from the host computer Gigabit 

NIC. See 

"

 for secure cables. 

•  A single 12-pin Hirose male connector for camera power plus trigger, strobe and general I/O signals. The 

suggested female cable mating connector is Hirose model HR10A-10P-12S.  

The Genie has one multicolor LED to provide a simple visible indication of camera state (see figure below and 
section 

" on page 22

). Additionally the RJ45 has two LEDs for network status conditions.  

The following figure of the Genie back end shows connector and LED locations. See 

"

on page 89

 for details on the Genie connectors and camera mounting dimensions.