3com DSA-3CV1001-02 Manual De Usuario
Installing the VCN Access Point
23
Mounting the VCN
Access Point on a
Wall
To mount the VCN AP on a wall perform the following tasks.
1 Apply the paper template to the wall as shown in
Figure 7 Using the Paper Template to Mark the Wall
The partially curved edge of the template corresponds to the curved cover
that is part of the VCN AP front panel.
that is part of the VCN AP front panel.
2 Remove the cover by sliding it downward and then pulling it outward.
See
Figure 8 Removing Curved Cover
All three holes in the VCN AP are plugged.
3 Remove the plugs from the two large holes by prying them out with the
tip of your screwdriver.
4 Remove the plug from the small hole by forcing it out from the bottom
with a pointy instrument (for example a nail).
Fax-M odem
ETH ERN ET
Li
ne
Pow
er
S c re w h o le