VIVOTEK IP2112 Manual De Usuario

 

                                                                         

 

49

 

 

 

 

After the power has been turned on, Network Camera will perform a self-diagnostic to 
detect any hardware defects. The following table lists the LED patterns in general 
conditions. In case of any fatal error, the LED will blink in another pattern.   

Condition LED 

color 

During self-diagnostic after power on 

Blink in interchanged green and red 

Ethernet signal is lost 

Steady red till Ethernet is detected 

Before network is setup 

No LED of sign till IP address is set 

After network is setup 

Blink green once per second 

Any hardware failure 

Other patterns 

 
 

 

Sometimes resetting the system can make the system 
back to normal state. If the system still has problems after 
reset, restore the factory settings and install again. 
RESET: Poke the wrench to click on the button. 
RESTORE:    

1. Poke the wrench to press on the button continuously. 
2. Wait for self-diagnostic to run twice. 
3. Withdraw the wrench as soon as the second   

  Restore the factory defaults will lose any previous settings. Reset or restore the 

system after power on.